Mk-diamond Saw Tent Manuel d'utilisateur télécharger pdf

SAW ASSEMBLY INSTRUCTIONS

1315 Storm Parkway, Torrance, CA 90501 |

P 800.421.5830 | www.mkdiamond.com | F 310.539.5158

Step (1) Always check the oor for high nail heads, screws, and

other sharp objects before setting up your SAW TENT. Lay down

a sheet of plastic to protect the oor and then lay out the black

plastic pan.

The MK Diamond Saw Tent is designed to

contain the spray and debris when cutting tile or

masonry material. You can cut anywhere without

the worry of your surroundings. It is easy to

assemble and retracts into a small storage bag.

Step (2) Cut a piece of ¼ ” Backer Board 46.5” X 59.5” to install

inside the black pan. The Backer Board will give the Saw Tent

aluminum structure a rm base to stand on. The Backer Board

will also protect the black pan from being punctured by sharp

pieces of tile falling off the tile saw.

Step (3) Take the aluminum structure and press it until it extends

fully and locks open. Pull the aluminum frame into the four corners

of the pan until it is fully extended and tight. The pan will now be

open and the perimeter will be standing up, ready to receive the

clear plastic cover.

Step (4) Install supports for both sides. Now would be a good

time to set up your saw stand and the saw, both inside the

Saw Tent.

1 2

SAW ASSEMBLY INSTRUCTIONS1315 Storm Parkway, Torrance, CA 90501 | P 800.421.5830 | www.mkdiamond.com | F 310.539.5158Step (1) Always check

Page 2

1315 Storm Parkway, Torrance, CA 90501 | P 800.421.5830 | www.mkdiamond.com | F 310.539.5158Step (6) Pre-set your hood by closing the two

Pas de commentaire

Mk-diamond Saw Tent Manuel d'utilisateur