Mk-diamond MK-101Pro24 JCS Manuel d'utilisateur télécharger pdf (Page 43)

MK-101 Pro24 JCS TROUBLESHOOTING

90º-alignment verication ensures the blade cuts tile straight up and down and not at an angle.

The Diamond blade must be removed and reinstalled when removing the blade guard.

(A)

Remove Blade Guard and

water pan.

(B)

Position Square on Movable

Cutting Table against

the Diamond Blade.

(C)

Verify the Diamond

Blade is Square to the

Movable Cutting Table.

(D)

If not Square, loosen Movable

Cutting Table Wheel Assembly

to adjust.

(E)

Move Wheel Assembly

up or down to Square the

Movable Cutting Table.

(F)

After Squaring, tighten Movable

Cutting Table Wheel Assembly.

(G)

Re-verify the Diamond Blade

is Square to the Movable

Cutting Table.

90° ALIGNMENT VERIFICATION

NOTE: If the blade is misaligned following 90º-alignment verication, return the saw to

MK Diamond for repair.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 59 60

Pas de commentaire

Mk-diamond MK-101Pro24 JCS Manuel d'utilisateur Page 43