Mk-diamond Saw Tent Manuel d'utilisateur télécharger pdf (Page 2)

1315 Storm Parkway, Torrance, CA 90501 |

P 800.421.5830 | www.mkdiamond.com | F 310.539.5158

Step (6) Pre-set your hood by closing the two zippers creating

the hood shape. Make sure the Velcro, at the base, is on the

outside. This Velcro will later attach to the Velcro that is sewn

on the inside of the black pan. Grab the hood and approach the

Saw Tent from the rear of the unit. Envelope the tubular frame

structure with the clear plastic hood and make it tight. Now come

around to the front and attach the Velcro strap to the front cross

member in the middle. Next, work the plastic sheeting around

the frame, leaving the perimeter, with the Velcro outside of the

black pan. After you have attached all other Velcro pieces to the

aluminum frame, work your way around the perimeter pushing

the clear plastic sheeting (with the Velcro attached) to the inside

of the black pan. As you work your way around, you will be join-

ing the two horizontal strips of Velcro together. What this does is

make sure the water spray will run down the vertical walls and

drip inside the pan, thus containing the water. Use the handy

plug opening in the back.

Step (5) Install top supports as shown in the drawing, one in the

back, middle, and the third against the 45 degree elbow. These

three supports help keep the plastic enclosure away from the

saw and bring strength to the whole structure.

Storing

Reverse these instructions to take the Saw Tent apart. After you remove the saw and stand, use a

sponge to remove any water that has accumulated from use. Take care to clean all parts and roll up

the Saw Tent, put it into the storage case, and it will be ready to use on the next job.

SAW ASSEMBLY INSTRUCTIONS

1 2

Pas de commentaire

Mk-diamond Saw Tent Manuel d'utilisateur Page 2